Product Categories
(Total 12 Products for Electric Motor With Encoder)
Encoder and decoder in communication
The encoder is a rotary sensor that converts the rotation displacement into a series of digital pulse signals. These pulses can be used to control the angular displacement. If the encoder is combined with a gear pin or screw screw, it can also be used to measure linear displacement
I. Overview
This device is suitable for all movable car-bottom elevators that require overload signals and escalators that require energy-saving operation. It can also be used for mechanical limit or proximity switches. This device has a very high cost performance. It uses Hall sensors to achieve non-contact induction...
Absolute rotary encoder high-speed end installation: installed on the power motor shaft end (or gear connection), this method has the advantage of high resolution
Magnetoelectric proximity switch encoder
Each position of the absolute encoder corresponds to a certain digital code, so its indication is only related to the start and end positions of the measurement, and has nothing to do with the middle process of the measurement.
The COM terminal of the encoder is connected with the PLC input COM terminal, and the A and B two-phase pulse output lines are directly connected with the PLC input terminal. When connecting, pay attention to the response time of the PLC input.
Rotary encoders output pulses during rotation, and the position (plc) is known by counting equipment. We usually use incremental encoders. The output pulse signal of incremental encoders can be directly input to the PLC, using the high speed of the PLC. The counter counts its pulse signal to obtain the measurement...
The incremental encoder converts the displacement into a periodic electric signal, and then converts this electric signal into a counting pulse, and the number of pulses is used to indicate the magnitude of the displacement.
The biggest difference between an incremental encoder and an absolute encoder: In the case of an incremental encoder, the position is determined by the number of pulses calculated from the zero mark, while the position of an absolute encoder is the reading of the output code definite.
Electric photocell sensor encoder
The form of the encoder shaft: the shaft is extended and must be equipped with a coupler before it can be used; the hollow shaft, without a coupler, can be directly used on the other equipment.
The output form of the encoder: NPN open collector output, PNP open collector output, complementary output, voltage output, linear drive output. Determine the output form of the encoder according to what signal the subsequent device input can receive (which can be reflected in the naming rule).
The characteristic of the rotary encoder: no need to return to origin when starting (only for absolute type). The absolute rotary encoder outputs the rotation angle in parallel in absolute value.
The encoder reasonably selects the output signal transmission medium of the photoelectric detection device, and uses twisted-pair shielded cables to replace ordinary shielded cables.
Categories
High Quality Products
Send Us a Message
We didn't put all products on website. If you can't find the product you're looking for, please contact us for more information.
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
